, Omesol [ Engineering, Management, Finance & Training Solutions Provider]
 
Menu

PLC Programming & Troubleshooting

Training Mode :  Online Courses  
Duration :  24 Hours   Fee :  400 USD  

Objective

Provide an adequate practical exposure and knowledge of PLC programming and troubleshooting.

Who Will Benefit

  • Student
  • Fresh Graduates
  • Professionals

Course Detail

Module 1

Introduction
  • Introduction and brief history of PLC controls
  • Alternative control systems - Where Do PLCs Fit In?
  • Why PLC control has become so widely accepted?
  • Lingering concerns about PLC control
Fundamentals Of PLC Hardware
  • Block diagram of typical PLC
  • PLC processor module - memory organization
  • Input and output section - module types
  • Power supplies
Fundamentals Of PLC Control Software
  • Fundamental ladder logic instruction set
  • Comparison of different manufacturers, memory and data representation and instruction code
Using Ladder Logic For Simple Digital Functions
  • Basic rules
  • Comparison of relay ladder diagrams
  • Contact 'NORMAL' states
  • Compliance with IEC 61131

Module 2

  • Introduction to the Demo
  • System Overview
  • Software Review
  • Setting the PG Interface
  • Configuring Hardware
  • Module Status
  • Memory Layout
  • Symbols
  • VAT Table
  • Bit Logic Instructions

Module 3

  • Numbering Systems
  • Load and Transfer Instructions
  • Timers
  • Counters
  • Data Blocks

Module 4

  • OB Blocks
  • Math Operations
  • Functions
  • Compare Operations
  • Function Blocks
  • Monitor With Path
  • Jump Instructions
PID Control

The importance of timing and scan time

When PID is not always appropriate:

  • Intermittent measurements
  • Long transport delays
Good Installation                 
  • Location of hardware
  • Good wiring practice
Building A PLC Panel, As Well As General Commissioning, Testing & Upgrading
  • Electrical design & construction
  • Problem Isolation & Faultfinding
  • Upgrading of control systems
Commissioning Of Inverters
  • Commissioning & installation
  • Simulation & testing
  • Using parameters
WINTEK SCADA / Wincc Flexible 2008
  • Introduction to the Demo
  • System Overview
  • Software
  • Setting the PLC AND HMI
  • Configuring Hardware
  • Module Status
  • Memory Layout
  • Symbols
  • Trends
  • Data Logging
  • Bar graphs
  • Designing tools
  • Communication
Practical Exercises

Throughout the course you will participate in hands-on Exercises using PLC, which will help You put theory to practice immediately!

 

To Top